Emission measurement

It is important in industrial companies that plants are run efficiently and that there is at the same time as little environmental pollution as possible in the process. Flue gas analysers help you here in terms of compliance with statutory emission-limit values, as well as monitoring and optimising thermal manufacturing processes.

I would like support.


Compliance Testing

Compliance Testing with testo 350
More on compliance testing

In most countries, operation of all types of industrial plants is subject to strict regulations governing exhaust gas emissions into the atmosphere.

  • Verify that the components defined as pollutants do not exceed certain limit values in the flue gas
  • Carry out a preliminary flue gas analysis before an official emissions reading
     

Efficiency testing

Efficiency testing with testo 340
More on effciency testing

Flue gas analysis instruments are one of the items of equipment that are used on a daily basis by service engineers to achieve optimum tuning of engines.

  • Tune the engine to the optimum operating parameters while complying with the limit value regulations in force
  • Avoid downtimes over the long term
     

Efficiency testing on ships

Efficiency testing on ships
More on ship motors

On ships, as little visible smoke should be produced as possible, and the soot content kept to a minimum. In shipbuilding, the smoke count also plays an important part.

  • Test whether the smoke count of marine diesel engines does not exceed the prescribed limit values
  • Prove the soot emission in the diesel exhaust to custormers

Emission measurement: Combined heat and power plant

Emission measurement on CHP systems with testo 350
More on CHP systems

In order to be able to ensure the efficiency of combined heat and power plants, it is important to monitor them with a suitable measuring instrument, not only in commissioning but also in the course of test measurements.

  • Extend the lifetime of the engine
  • Early identification of wear
  • Reduction of fuel consumption by the optimum adjustment of the ignition point

 

Emission measurement: boiler systems

Emission measurement on boiler systems with testo 340
More on boiler systems

The statutory emissions limit values are getting more and more strict, especially for NOX. For this reason, emissions values are determined on boilers and burners during commissioning, maintenance and for emissions measurements.

  • Assessing the cost-effectiveness of the system and the setting of the burner
  • Ensuring that the system complies with the legally established maximum values for flue gas loss and emissions
     

Emission measurement: gas turbine

Emission measurement on gas turbines with testo 350
More on gas turbines

A gas turbine must be tested at regular intervals to check whether it is running according to the manufacturer's specifications and adhering to emission limit values, for this reason it is important for efficient operation to have a reliable, highly precise measuring instrument to hand.

  • High measurement accuracy at low concentrations, thanks to precise COlow and NOlow sensors
  • Easy, precise test gas adjustment by the user