testo 320B - Flue Gas Analyser (standard kit)

Order-Nr.  0563 3223 80

The testo 320 basic features all the essential functions for carrying out flue gas analysis on domestic heating systems, including flue draught, pressure measurements, and differential temperature measurement. The flue gas analyser is easy to use with its full colour graphic display featuring a user-friendly menu guidance. The analyser measures both O2 and CO (4,000ppm sensor fitted as standard) and can also display calculated parameters such as combustion ratio, CO2, etc.

Product Description

The testo 320 basic features all the essential functions for carrying out flue gas analysis on domestic heating systems, including flue draught, pressure measurements, and differential temperature measurement. The flue gas analyser is easy to use with its full colour graphic display featuring a user-friendly menu guidance. The analyser measures both O2 and CO (4,000ppm sensor fitted as standard) and can also display calculated parameters such as combustion ratio, CO2, etc.

Standard kit features include :

* 4,000ppm CO sensor with automatic pump shut off to help prevent saturation.
*10 user selectable fuels
*rechargable Li-ion battery
*tightness and let-by pressure test routines included in menu (requires pressure connection adaptor)
*Flow and return temperature measurement (using additional accessory probes)
*Soft carry case with shoulder strapx
*Independently tested according to EN 50379 Parts 1-3

 

Delivery Scope

testo 320B Flue Gas Analyser, rechargeable battery and calibration protocol, Flue Gas Probe (180mm x 6mm diameter), Soft carry case with shoulder strap, AC/USB power supply.

Standard gas sampling probes

£ 142.00
incl. VAT £ 170.40

Temperature probes

£ 59.00
incl. VAT £ 70.80

Accessories

CPA 1 Accessory Kit

Order Number: 300554 1000

£ 185.00
incl. VAT £ 222.00
testo fast printer IRDA

Order Number: 0554 0549

£ 199.00
incl. VAT £ 238.80
£ 77.00
incl. VAT £ 92.40
USB mains unit incl. cable

Order Number: 0554 1105

£ 36.50
incl. VAT £ 43.80

Measuring the flue gas parameters of the burner (CO, O2, and temperature, etc.)

The flue gas measurement for a heating system helps to establish the pollutants released with the flue gas (e.g. carbon monoxide CO or carbon dioxide CO2) and the heating energy lost with the warm flue gas. In some countries, flue gas measurement is a legal requirement. It primarily has two objectives:

 

  • Ensuring the atmosphere is contaminated as little as possible by pollutants; and
  • energy is used as efficiently as possible.

 

Stipulated pollutant quantities per flue gas volume and energy losses must never be exceeded. Measurement in terms of results required by law takes place during standard operation (every performance primarily using the appliance). Using a Lambda probe (single hole or multi-hole probe), the measurement is taken at the centre of flow in the connecting pipe (in the centre of the pipe cross-section, not at the edge) between the boiler and chimney/flue. The measured values are recorded by the flue gas analyzer and can be logged either for print out or transfer to a PC at a later stage.

Measurement is taken by the installer at commissioning, and if necessary four weeks later by the flue gas inspector/chimney sweep, and then at regular intervals by the authorised service engineer.

Product Brochures

Software