Spare sintered filters (2 off)

Order-Nr. 0600 9766

• Easy probe shaft replacement via quick-change click system
• NO₂/SO₂ special hose (length: 2.2 m)

Order-Nr. 0600 8764

• Easy probe shaft replacement via quick-change click system
• NO₂/SO₂ special hose (length: 2.2 m)

Order-Nr. 0600 9767

• Easy probe shaft replacement via quick-change click system
• NO₂/SO₂ special hose (length: 2.2 m)

Order-Nr. 0600 8765

• Easy probe shaft replacement via quick-change click system
• NO₂/SO₂ special hose (length: 2.2 m)

Order-Nr. 0600 8766

• Easy probe shaft replacement via quick-change click system
• Preliminary filter offers protection from dusty flue gases

Order-Nr. 0600 8767

• Easy probe shaft replacement via quick-change click system
• Preliminary filter offers protection from dusty flue gases

Order-Nr. 0632 3340

• Flue gas analysis with up to 4 gas sensors - freely configurable with sensor change on site by the user
• testo 340 flue gas analyzer, calibration protocol, shoulder strap, O₂ sensor and integrated flow and pressure difference measurements   

Order-Nr. 400563 3342

• Flue gas analysis with up to 4 gas sensors - freely configurable with sensor change on site by the user
• Optimize the combustion process and increasing fuel efficiency

Order-Nr. 400563 3343

• Flue gas analysis with up to 4 gas sensors - freely configurable with sensor change on site by the user
• For combustion tuning IC engines (spark-Ignited rich and lean burn and compression-ignited diesel engines)

Order-Nr. 0632 3510

• Flue gas analysis with up to 6 gas sensors - freely configurable with sensor change on site by the user
• Increased measurement range for unlimited measurements even when gas concentrations are higher

Order-Nr. 0632 3511

• Flue gas analysis with up to 6 gas sensors - freely configurable with sensor change on site by the user
• testo 350 Analysis Box just as easy to use when not positioned at measurement site

Order-Nr. 400563 3512

• Optimize fuel efficiency and reduce emissions
• Identify and troubleshoot bad burners, inlet air, or fuel delivery problems

Order-Nr. 400563 3513

• For EPA Emissions Compliance testing – EPA test methods OTM 39, OTM 38, 7E, CTM-030, CTM-034, ASTM D6522, SCAQMD 1110.2, SCAQMD 1146.  Its also used for state, local and company testing.
• For combustion tuning IC engines (spark-Ignited rich and lean burn and compression-ignited diesel engines)

Order-Nr. 400563 3514

• Measures Low NOx (NO + NO2 with 0.1 ppm) Low CO (0.1 ppm), O2, on EPA dry basis
• Confirm emissions baseline and permit status