logo
  1. Home
  2. Cienka sonda wilgotności z wbudowaną elektroniką, zawiera 4 ...

Cienka sonda wilgotności z wbudowaną elektroniką, zawiera 4 ... - for material moisture

0636 2135
2 116,00 Zł 2 602,68 Zł
  • Measurement of the material moisture via the equilibrium moisture content
  • Slim design (Ø 4 mm) with remote electronics – ideal for tight measuring points
  • Cienka sonda wilgotności z wbudowaną elektroniką, zawiera 4 dołączalne końcówki teflonowe do pomiaru równowagi wilgotności materiału
    Equilibrium moisture content is ideally measured in a bore hole in the material. The thin humidity probe with a probe shaft diameter of 4 mm (connected to an appropriate measuring instrument) is good to use here, so as to keep the bore hole as small as possible. It should be protected against contamination by a PTFE cap during measurement. The bore hole can easily be sealed with adhesive modelling clay.

    The attached measuring instrument (testo 635) automatically calculates the material moisture based on the measured equilibrium moisture content and shows this in the display. The material moisture calculation is available for the following materials: concrete, high-insulation brick, solid brick, hard wood, soft wood, aerated concrete, particle board, calcium sulphate flowing screed, cement flowing screed and lime sand brick.

    Thin humidity probe (Ø 4 mm) with PTFE protective cap and adhesive modelling clay (4 items), including fixed cable.

    Pomiar temperatury - NTC

    Zakres pomiarowy
    0 do +40 °C
    Dokładność
    ±0,2 °C
    *proszę również wziąć pod uwagę niepewność urządzenia.

    Wilgotność - czujnik pojemnościowy

    Zakres pomiarowy
    0 do +100 %RH
    Dokładność
    ±2 %RH przy +25 °C (+2 do +98 %RH)
    Stabilność długoterminowa: ±1 %RH / year
    ±0,15 % wilg. wzg./K (k=1)
    *dokładność czujnika odpowiada dokładności systemu.

    Ogólne dane techniczne

    Średnica sondy
    4 mm
    Długość próbnika
    60 mm