Fűtött ipari érzékelő szett

Rendelési szám  0600 7630

  • A high degree of measuring accuracy, even if the flue gas contains high concentrations of NO2 or SO2

  • Measurements in applications with flue gas temperatures of up to 600 °C

  • Short time needed to set up the heated industrial probe (ready for operation in 20 minutes maximum)

  • Very easy to handle

Fűtött ipari érzékelő szett
Szett tartalma:
- Fűtött érzékelő szár, füstgáz hőmérséklet 600 °C-ig
- Fűtött füstgáz mintavevő szonda tömlővel, 4 m
- K típusú hőelem, 1,2 m


A heated sampling system is necessary when the situation requires maximum measuring accuracy (e.g. if there are high concentrations of NO2 or SO2 in the flue gas) or if a heated system is a legal requirement in your country. A heated system prevents condensation of the flue gas being measured within the sampling system. Gaseous media are transported over short and long distances at constant temperature.

For applications of this kind, which require heated sampling, we offer our heated industrial probe set for the extractive sampling of flue gas being analyzed. It can be used in combination with the testo 350 or testo 340. Easy to handle, the heated industrial probe set prevents condensate forming and prevents the temperature within the sampling system falling below the flue gas dewpoint.

The heated sampling tube (600 °C) can be extended to a max. 3 m using optional extension tubes. The thermocouple (2.2m) can be added as an accessory to enable you to carry out simultaneous temperature measurement with a 2m long probe. You can also install an optional preliminary filter for measurements involving a high dust load.


You can use the heated industrial probe set (in combination with the testo 350 or testo 340) for the following applications:

  • Emissions measurement to monitor prescribed limit values
  • Measurements on a variety of installations / trial set-ups in laboratories
  • Emissions check measurements within the flue gas cleaning system
  • Official emissions measurement (compliance testing, more information under the “Applications” tab)

You can use other accessories to put together an application-specific sampling solution.


Szállítási kiszerelés

The heated industrial probe set consists of the following components:

  • Heated probe shaft up to 600 °C flue gas temperature
  • Heated gas sampling hose
  • Thermocouple type K

Related Products

  • testo 340 testo 340
    testo 340
  • testo 350 füstgázelemző testo 350
    testo 350 füstgázelemző
  • testo 350 kezelőegység testo 350
    testo 350 kezelőegység